Circuit Breaker & Automatic Transfer Switch
Moulded Case Circuit Breaker
Air Circuit Breaker
Miniature Circuit Breaker
Residual Current Circuit Breaker
Dual Power Automatic Transfer Switch
Motor Protection Circuit Breaker
Surge Protective Device
Relay , Contactor , Starter & Frequency Inverter
Thermal Relay
General Relay
Timer Relay
Relay Socket
Solid State Relay
Contactor
Starter
Frequency Inverter
Power Equipment and Transformer and Solar
Voltage Stabilizer
Switching Power Supply
Control Transformer
Voltage Regulator
Ups & Eps
Inverter
Power Transformer
Solar Products
Instruments
KWH Meter
Panel Meter
Shunt
Current Transformer
Multimeter
Temperature Controller
Thermocouple & Thermal Resistance
Small Ptc Heater & Small Thermostat
Compass
Indicator & Switch & Warning Products
Indicator
Pushbutton Switch
Motive Switch
Limit Switch
Micro Switch
Toggle Switch
Foot Switch
Universal Changeover Switch
Float Switch
Warning Light
Siren
Warning Bell
Fuse & Disconnector
Low Voltage Fuse
Fuse Disconnector
High Voltage Fuse
Welder & Rectifier
Welder
Rectifier
Plug & Socket & Isolating Switch & Distribution Box
Industrial Plug & Socket
Weather Protected Isolating Switch
Distribution Board
Elctrical Accessories
Terminal
Cable Tie
Clips
Cable Gland
Cabinet Lock
Others
Axial Fan
Ex Products

● Address: NO.208, Weiqi Road, Yueqing Economic Development Zone, YueQing, Zhejiang, China.

● Worktime : 24 hours online   service

● Fax:0086 577 5293 1777

● Tel:0086 577 6273 1666

ADM3 Sreies Moulded Case Circuit Breaker

Submit Comments
*Name
Phone
*Email
Address
*Message

ADM3 series moulded case circuit breaker (hereinafter referred to as circuit breaker)

is a brand new circuit breaker researched and developed by our company. It has a

brand new industrial appearance design, which makes the products fully show the

sense of quality of fashion and atmosphere. The product specification can cover the

current of frame size from 125A to 800A. The exquisite product volume and the

independent installation function of accessories brought by the detachable surface

cover design greatly improve the convenience of the product. The product has small

volume, high breaking, short arc, rated insulation voltage up to 1000V, suitable for

power distribution network of AC 50Hz or 60Hz, rated working voltage to 690V, rated

working current from 10A to 800A, used to distribute electrical energy and protect the

circuit and power equipment from overload, short circuit and undervoltage fault

damage; at the same time as the line infrequently switching, motor infrequently starting

and overload, short circuit and undervoltage protection functions.

The circuit breaker has isolation function, and the corresponding symbol is:

The circuit breaker can be installed vertically or horizontally.

The products comply with IEC 60947-2 and GB/T14048.2 standard requirements.

2. Normal working conditions and installation conditions

2.1 Normal working conditions

(1) The product has a protection level of IP30 and a pollution level of 3.

(2) The ambient air temperature should not be higher than +40 or -5 , and the

average temperature of 24h should not be higher than +35

.

(3) The elevation of the installation site shall not exceed 2000m.

(4) When the ambient temperature is +40 , the relative humidity of the atmosphere

does not exceed 50%. A relatively high relative humidity can be obtained at a lower

temperature, for example, 90% at 20 . Special measures should be taken for

occasional condensation due to temperature changes.

(5) In the medium without explosion risk, and there is no place in the medium where

enough gas and conductive dust can corrode the metal and damage the insulation.

(6) Where there is no rain or snow.

(7) Installation type: applicable to front fixed plate, rear fixed plate, front insert plate,

rear or pull out type.


ADM3 series moulded case circuit breaker (hereinafter referred to as circuit breaker)

is a brand new circuit breaker researched and developed by our company. It has a

brand new industrial appearance design, which makes the products fully show the

sense of quality of fashion and atmosphere. The product specification can cover the

current of frame size from 125A to 800A. The exquisite product volume and the

independent installation function of accessories brought by the detachable surface

cover design greatly improve the convenience of the product. The product has small

volume, high breaking, short arc, rated insulation voltage up to 1000V, suitable for

power distribution network of AC 50Hz or 60Hz, rated working voltage to 690V, rated

working current from 10A to 800A, used to distribute electrical energy and protect the

circuit and power equipment from overload, short circuit and undervoltage fault

damage; at the same time as the line infrequently switching, motor infrequently starting

and overload, short circuit and undervoltage protection functions.

The circuit breaker has isolation function, and the corresponding symbol is:

The circuit breaker can be installed vertically or horizontally.

The products comply with IEC 60947-2 and GB/T14048.2 standard requirements.

2. Normal working conditions and installation conditions

2.1 Normal working conditions

(1) The product has a protection level of IP30 and a pollution level of 3.

(2) The ambient air temperature should not be higher than +40 or -5 , and the

average temperature of 24h should not be higher than +35

.

(3) The elevation of the installation site shall not exceed 2000m.

(4) When the ambient temperature is +40 , the relative humidity of the atmosphere

does not exceed 50%. A relatively high relative humidity can be obtained at a lower

temperature, for example, 90% at 20 . Special measures should be taken for

occasional condensation due to temperature changes.

(5) In the medium without explosion risk, and there is no place in the medium where

enough gas and conductive dust can corrode the metal and damage the insulation.

(6) Where there is no rain or snow.

(7) Installation type: applicable to front fixed plate, rear fixed plate, front insert plate,

rear or pull out type.